To Next Page

To Previous Page

The 1920S 8G Switch can also be powered on by a PoE PD connection to Port 1.

Switch features

The features of the 1920S Switches include:

• 8, 24, or 48 auto-sensing 10/100/1000BASE-T RJ-45 ports.

• 2 or 4 SFP slots for HPE SFP transceivers (1920S 24G, 1920S 24G PoE+, 1920S 24G PPoE+ 1920S

48G, and 1920S 48G PPoE+ Switches only)

• plug-and-play networking—all ports are enabled—just connect the network cables to active network

devices and your switched network is operational.

• IEEE 802.3ab Auto MDI /MDI-X on all twisted-pair ports, meaning that all connections can be made

using straight-through twisted-pair cables. Cross-over cables are not required, although they will also

work. The pin operation of each port is automatically adjusted for the attached device: if the switch

detects that a 10/100/1000 Mbps switch or hub is connected to the port, it configures the port as MDI;

if the switch detects that a 10/100/1000 Mbps end-node device is connected to the port, it configures

the port as MDI-X.

• all switches support IEEE 802.3az Energy Efficient Ethernet (EEE) features that reduce power

consumption when connected with EEE-compliant client devices.

• automatic learning of MAC addresses in each switch’s 8K-address (8- and 24-port switches) or 16K-

address (48-port switches) forwarding table.

• automatically negotiated full-duplex operation for all 10/100/1000BASE-T RJ-45 ports when connected

to other auto-negotiating devices

• easy management of the switch through several available interfaces:

◦ Web browser interface — an easy to use built-in graphical interface that can be accessed from

common Web browsers.

◦ Intelligent Management Center (iMC) — allows network administrators to discover and map the

switches within their network and launch the built-in graphical interface from within iMC to configure

the switches.

• support for up to 64 IEEE 802.1Q-compliant VLANs so you can divide the attached end nodes into

logical groupings that fit your business needs.

• support for up to 16 trunks (48-port switches) so you can assign physical links to one logical link

(trunk) that functions as a single, higher-speed link providing dramatically increased bandwidth.

• support for many advanced features to enhance network performance—for a description, see the

Management and Configuration Guide.

• download of new switch software for product bug fixes.

12 Switch features

Questions and Answers:

Need help?

Do you have a question about the HPE OfficeConnect 1920S Series and is the answer not in the manual?

HPE OfficeConnect 1920S Series Specifications

General