HPE OfficeConnect 1920S Series

HPE OfficeConnect 1820 Series SwitchJ9980A
SFP Ports
Wall or under-table mounting
You can mount the 1920S 24- and 48-port switches on a wall with either the front or rear panel facing up.
WARNING:
For safe operation, please read Installation precautions on page 14 before mounting the switch.
Wall mount the switch with the network ports facing up or down.
CAUTION:
The switch should be mounted only to a wall or wood surface that is at least 1/2-inch (12.7 mm)
plywood or its equivalent.
To mount the 1920S 24- and 48-port switches, follow these steps:
Procedure
1. Use a #1 Phillips (cross-head) screwdriver and attach the mounting brackets to the switch with the
included 8-mm M4 screws.
2. Attach the switch to the wall or wood surface with two 5/8-inch number 12 wood screws (not included).
To mount the 1920S 8-port switches, follow these steps:
20 Wall or under-table mounting