11. Connect the serial port cable .
12. Install the riser cage.
13. Install the access panel .
14. Install the server into the rack .
15. Connect all peripheral cables to the server.
16. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
17. Power up the server .
18. If removed, install the front bezel .
19. To configure the serial port setting:
a. From the boot screen, press F9F9 to access the UEFI System Utilities.
b. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration (RBSU) > System Options > Serial
Port Options > Embedded Serial Port.
c. Select a setting.
d. Press F12F12 key to save your selection.
e. Click Yes-Save Changes.
f. Click Reboot.
This installation is complete.
To Next Page
Loading...
