HPE ProLiant DL20 Gen10 Plus - Remove the Processor Air Baffle

Remove the processor air baffleRemove the processor air baffle
CAUTION: CAUTION: For proper cooling, do not operate the server without the access panel, baffles, or blanks installed.
The processor air baffle (P48355-B21) is present when a processor that has a TDP ≥ 95 W is installed.
ProcedureProcedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the processor air baffle.
Remove the processor air baffle 42