HPE ProLiant DL20 Gen10 Plus - Table of Contents

Table of contentsTable of contents
1 Component identification
1.1 Front panel components
1.1.1 iLO Service Port
1.2 Front panel LEDs and buttons
1.2.1 Server UID LED
1.2.2 Using the UID button to view the Server Health Summary
1.2.3 Front panel LED power fault codes
1.3 Rear panel components
1.4 Rear panel LEDs
1.5 System board components
1.5.1 System maintenance switch descriptions
1.5.2 DIMM slot location
1.5.3 DIMM label identification
1.6 Drive bay numbering
1.7 HPE Basic Drive LED definitions
1.8 PCIe4 slot description
1.9 Riser board components
1.10 M.2 SSD pass-through card components
1.11 HPE NS204i-p NVMe OS Boot Device components
1.12 HPE NS204i-p NVMe OS Boot Device LED definitions
1.13 Fan numbering
1.14 Fan mode behavior
1.15 Trusted Platform Module 2.0
1.15.1 Trusted Platform Module 2.0 guidelines
1.15.2 BitLocker recovery key/password retention guidelines
2 Operations
2.1 Remove the front bezel
2.2 Power up the server
2.3 Power down the server
2.4 Remove the server from the rack
2.5 Remove the access panel
2.6 Remove the processor air baffle
2.7 Install the processor air baffle
2.8 Remove the riser cage
2.9 Install the riser cage
2.10 Install the access panel
2.11 Install the server into the rack
3 Setup
3.1 Initial system installation
3.1.1 HPE Installation Service
3.1.2 Setting up the server
3.2 Operational requirements
3.2.1 Space and airflow requirements