https://www.hpe.com/info/ilohttps://www.hpe.com/info/ilo
The iLO management port is connected to a secure network.
b. Using a browser, navigate to the iLO web interface, and then log in.
Note the following:
The iLO host name is on the serial number/ iLO information pull tab on the front panel.
If a DHCP server assigns the IP address, the IP address appears on the boot screen.
If a static IP address is assigned, use that IP address.
The default login credentials are on the serial number/ iLO information pull tab on the front panel.
c. Enter the iLO login name and password, and then click Log In.
d. In the navigation tree, click the Remote Console & Media link, and then launch a remote console.
6. Perform the following steps:
a. Configure the initial server setup .
b. Set up the storage .
c. Deploy an OS or virtualization software.
d. After the OS is installed, update the drivers.
https://<iLO hostname or IP address>
To Next Page
Loading...
