a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack
• Remove the server from the rack
5. Remove the access panel.
6. Remove the air baffle.
7. Prepare the replacement fan module.
a. If replacing the fan module only, disconnect the spare fan 3 power extension cable from the
replacement fan module. Retain the spare cable for future use.
b. Remove the screws.
c. Remove the replacement fan module from the assembly.
NOTE:
The assembly that comes in the spare fan kit is not supported in the server.
8. If replacing fan 1 or fan 2, do the following:
a. Disconnect the fan cables.
42 Removal and replacement procedures
To Next Page
Loading...
