For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
Replacing the front I/O assembly
About this task
CAUTION:
To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any installation, removal, or replacement procedure. Improper grounding can cause
electrostatic discharge.
Procedure
1. If installed, remove the security bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Remove all USB devices from the front I/O assembly.
5. Do one of the following:
• Extend the server from the rack
• Remove the server from the rack
6. Remove the access panel.
7. Remove the air baffle.
8. Disconnect the front I/O assembly cable.
9. Remove the front I/O board.
62 Replacing the front I/O assembly
To Next Page
Loading...
