To replace the component, reverse the removal procedure.
Replacing the system board
About this task
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:
To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any installation, removal, or replacement procedure. Improper grounding can cause
electrostatic discharge.
CAUTION:
To avoid ESD damage, when removing electrostatic-sensitive components from the failed system board,
place the components on a static-dissipating work surface or inside separate antistatic bags.
Procedure
1. If installed, remove the security bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack
• Remove the server from the rack
5. Remove the access panel.
6. Remove the PCI riser cage.
7. Remove the air baffle.
Replacing the system board 63
To Next Page
Loading...
