3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove the M.2 air baffle .
9. Remove the fans.
10. Remove the fan board.
Retain the screws for further use.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a serial portRemoving and replacing a serial port
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a hex screwdriver available.
About this taskAbout this task
ProcedureProcedure
1. Power down the server.
To Next Page
Loading...
