16. Install the NS204i-u + secondary low-profile riser cage .
17. Connect the boot device signal and power cables to the system board .
18. Install the access panel .
19. Install the server into the rack.
20. Connect all peripheral cables to the server.
21. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
22. Power up the server.
23. Verify the Online/Activity LEDs on the HPE NS204i-u Boot Device are in solid green.
ResultsResults
The installation is complete.
Installing the Installing the boot deviceboot device security cover in a preconfigured server security cover in a preconfigured server
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this taskAbout this task
In a preconfigured server that ships with the boot device already installed in the NS204i-u + secondary low-profile riser cage, the accessory
bag in the server box includes the security cover for the boot device. If you want to prevent hot-plug access to the SSDs on the boot device,
install this security cover.
ProcedureProcedure
1. Back up all server data.
2. Power down the server.
3. Remove all power:
To Next Page
Loading...
