Server configurationServer configuration Rack rail optionRack rail option Minimum rail lengthMinimum rail length Adjustable rail rangeAdjustable rail range
SFF drive Rail option #2
(P52351-B21)
714.32 mm (28.12 in) 609.60 mm to 918.10 mm (24.00
in to 36.15 in)
LFF/E3.S drive Rail option #3
(P52341-B21)
787.55 mm (30.00 in)
Accelerator-optimized Rail option #7
(P52339-B21)
852.91 mm (33.58 in)
SubtopicsSubtopics
Installing the friction rack railInstalling the friction rack rail
Installing the friction rack railInstalling the friction rack rail
PrerequisitesPrerequisites
Make sure that the rack rail option is compatible with the server configuration.
Small slotted screwdriver—This tool is required if you are intended to install the server in a threaded round-hole rack.
ProcedureProcedure
1. Attach the inner rails to the server:
a. Insert the spools on the sides of the server through the keyed slots on the rails.
b. Slide the rail towards the rear panel to lock it into place.
2. Locate the orientation markers on the mounting rails.
The front end of the rails is marked as FRONT LEFTFRONT LEFT or FRONT RIGHTFRONT RIGHT.
To Next Page
Loading...
