HPE ProLiant DL360 Gen11

Installing the Chassis Intrusion Detection switch optionInstalling the Chassis Intrusion Detection switch option
PrerequisitesPrerequisites
Be sure you have the components included with the hardware option kit.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel .
5. Install the chassis intrusion detection switch behind the power supply bays.
HPE ProLiant DL360 Gen11 Server User Guide 105