7. Install the access panel .
8. Install the server in the rack.
9. Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server.
ResultsResults
Use the BIOS/Platform Configuration (RBSU) in the UEFI System Utilities to configure the memory mode.
For more information about LEDs and troubleshooting failed DIMMs, see " Systems Insight Display combined LED descriptions ."
NetworkingNetworking
SubtopicsSubtopics
Installing an OCP network adapterInstalling an OCP network adapter
Installing a PCIe network adapterInstalling a PCIe network adapter
Installing an OCP network adapterInstalling an OCP network adapter
PrerequisitesPrerequisites
Before you begin this procedure, make sure that the components included with the hardware option kit are available.
ProcedureProcedure
1. Power down the server .
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
To Next Page
Loading...
