To replace the component, reverse the removal procedure.
Removing and replacing the 2-SFF rear drive bay and riser
cage
Procedure
1. Power down the server (Powering down the server on page 41).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 42).
• Remove the server from the rack (Remove the server from the rack on page 42).
4. Remove the access panel (Remove the access panel on page 44).
5. Remove all drives (Removing and replacing drives on page 46).
6. Disconnect all cables from the drive backplane.
7. Remove the drive cage.
Removal and replacement procedures 71
To Next Page
Loading...
