To replace the component, reverse the removal procedure.
Removing and replacing a front LFF drive backplane
Procedure
1. Power down the server(Powering down the server on page 41).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 42).
• Remove the server from the rack (Remove the server from the rack on page 42).
4. Remove the access panel (Remove the access panel on page 44).
5. Remove the fan cage (Removing and replacing the fan cage on page 61).
6. Remove all drives (Removing and replacing drives on page 46).
7. Disconnect all cables connected the LFF backplane assembly.
8. Remove the LFF backplane assembly.
Removal and replacement procedures 77
To Next Page
Loading...
