Removal and replacement procedures 31
7.
Remove the drive from the drive cage.
To replace the component, reverse the removal procedure.
Slim optical drive
To remove the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the access panel (on page 24).
4. Remove the tower bezel ("Tower bezel" on page 25).
5. Place the server on its side.
6. To disconnect SATA and power cable from the slim optical disk drive and the system board, do the
following:
a. Disconnect SATA and power cable from the slim optical disk drive.
To Next Page
Loading...
