HPE ProLiant ML110 Gen10 - Page 38

• Network adapters
• Intelligent Provisioning
Set up the storage
7. Set up the storage. Do one of the following:
• To configure the server to boot from a SAN, see the following guide in the HPE website (https://www.hpe.com/
info/boot-from-san-config-guide):
HPE Boot from SAN Configuration Guide
• If an HPE Smart Array SR controller is installed, use HPE Smart Storage Administrator to create arrays:
a. From the boot screen, press F10 to run Intelligent Provisioning.
b. From Intelligent Provisioning, run
HPE Smart Storage Administrator.
• If no controller option is installed, do one of the following:
◦ AHCI is enabled by default. Deploy an OS or virtualization software.
◦ Disable AHCI, enable software RAID, and then create an array:
a.
From the boot screen, press F9 to run UEFI System Utilities.
b.
From the UEFI System Utilities screen, select System Configurations > BIOS/Platform Configuration
(RBSU) > Storage Options > SATA Controller Options > Embedded SATA Configuration > Smart Array
SW RAID Support.
c.
Enable Smart Array SW RAID Support.
d.
Save the configuration and reboot the server.
e.
Create an array:
I.
From the boot screen, press F9 to run UEFI System Utilities.
II.
From the UEFI System Utilities screen, select System Configuration > Embedded Storage: HPE
Smart Storage S100i SR Gen10 > Array Configuration > Create Array.
Deploy an OS or virtualization software
8.
Deploy an OS or virtualization software. Do one of the following:
• Press F10 at the POST screen.
For Intelligent Provisioning
330 and later, you are prompted to select whether you want to enter the Intelligent
Provisioning or HPE SMB Setup mode. After you have selected a mode, you must reprovision the server to change
the mode that launches when you boot to F10.
• Manually deploy an OS.
a. Insert the installation media.
Setup
38