8. Connect and route the S100i SATA cable assembly.
9. If removed, install the primary PCI riser cage.
10. Do one of the following:
• Install the secondary PCI riser blank.
• Install the secondary PCI riser cage.
11. Install the bayonet board.
12. Install the air baffle.
13. Install the server into the chassis.
14. Power up the server.
HPE Trusted Platform Module 2.0 Gen10 option
Overview
Use these instructions to install and enable an HPE TPM 2.0 Gen10 Kit in a supported server. This option
is not supported on Gen9 and earlier servers.
This procedure includes three sections:
HPE Trusted Platform Module 2.0 Gen10 option 57
To Next Page
Loading...
