36 User Manual
Figure 32: Cables within the Rail
Step 4. While holding the cables stably together in the blade’s rail with one hand, use your other
hand to secure the blades to the chassis. Screw the right blade with eight 4-40 flathead
screws, and the left blade with seven 4-40 flathead screws. The recommended torque is
0.49-0.54 Nm.
Figure 33: Attach the Blades to the System
In the next you will be attaching the rails to the chassis, before doing that, make sure
the cables are laid properly within them. Avoid using excessive pressure, as it can
damage the cables.
To Next Page
Loading...
