Chapter 6 Function Introduction Shenzhen Hpmont Technology Co., Ltd
―76― HD20 Series Inverters User Manual
No. Name Description Range
factory setting
F13.12 Idling exciting current of motor 2 0.00
99.99A
dependent on
inverter model
F13.14 Reserved
F13.16 V/f curve selection of motor 2 0
4
0
0: Line.
1: Square curve.
2: 1.2 exponential curve.
3: 1.7 exponential curve.
4: User-defined curve.
F13.17 V/f frequency value F3 of motor 2 F13.19
F13.04
0.00Hz
V/f voltage value V3 of motor 2
F13.19 V/f frequency value F2 of motor 2 F13.21
F13.17
0.00Hz
V/f voltage value V2 of motor 2
F13.21 V/f frequency value F1 of motor 2 0.00
F13.19
0.00Hz
V/f voltage value V1 of motor 2
F13.23 Torque boost of motor 2 0.0
30.0
2.0%
Cut-off point used for manual torque boost of motor 2
F13.25 Slip compensation gain of motor 2 0.0
300.0
100.0%
Slip compensation filter time of motor 2
F13.27 Slip compensation limitation of motor 2 0.0
250.0
200.0%
Compensation constant of motor 2
F13.29 Reserved
AVR (automatic voltage regulation) function of motor 2
F13.31 Oscillation-suppression mode of motor 2 0,1
0
Oscillation-suppression coefficient of motor 2
F13.33 Reserved
F13.35 Speed control proportional gain 1 of motor 2 0.1
200.0
20.0
Speed control integral time 1 of motor 2
F13.37 Speed control proportional gain 2 of motor 2 0.1
200.0
20.0
Speed control integral time 2 of motor 2
F13.39 Speed-loop PI switching frequency 1 of motor 2 0.00
50.00
10.00Hz
Speed-loop PI switching frequency 2 of motor 2
F13.41 Speed-loop integral limitation of motor 2 0.0
200.0 (F13.03)
180.0%
Speed-loop differential time of motor 2
F13.43 Speed-loop output filter time of motor 2 0.000
1.000
0.020s
F13.45 Reserved
Motor torque limitation when motor 2 is forward
0.0
200.0 (F13.03)
180.0%
F13.47 Motor torque limitation when motor 2 is reverse
Recreated torque limitation when motor 2 is forward
F13.49 Recreated torque limitation when motor 2 is reverse