HSD SM 141 D - Dipswitch Configuration

5 Installation and commissioning
46
HSD S.p.A. © - h0104k02a.fm091115
5.8 Dipswitch configuration
The dip-switch allows to set the Fieldbus address and the line end piece.
To access the dip-switch, release the screws and remove the plastic window A.
Once the configuration has been performed, close properly the plastic window
protecting the dip-switch, by fastening the screws.
A
LED 1
LED 2
LED 3
LED 4
LED 5
DSW1
DSW2
ON
OFF
1
2
3
4
5
6
7
8
limitswitches status limitswitches numbering
SM 141 CPH 400
A