Hotswapping the battery
Hotswapping allows you to change the battery without restarting the headset or connecting it to
a power source.
§ The headset has a front internal battery. It's intended to sustain power long enough for the
rear battery to be swapped with a freshly charged battery.
§ Make sure to swap out the battery when it still has some power. If the battery is completely
drained, the headset will turn off.
§ Hotswapping requires an additional battery (sold separately).
1. Take off the headset.
2. Remove the battery. See Removing the battery from the headset on page 22.
3. Attach your spare battery to the headset. See Attaching the battery to the headset on page
14.
4. Put the headset back on. The headset will resume where you left off.
Make sure to charge the original battery after you change it out.
Setup (headset and controllers)
Turning the headset on and off
§ To turn on your headset, press and hold the power button for around three seconds.
§ To turn off your headset, do any of the following:
§ Whether your headset is currently active or in standby mode, press and hold the
power button until the battery LEDs start flashing one after the other. Wait for all the
battery LEDs to completely turn off.
§ Press and hold the headset button until the Power menu appears and then select
Shutdown.
Setting up your headset for the first time
The easiest way to set up VIVE Focus Vision is with VIVE Manager.
To find out where you can download VIVE Manager, see What phones does VIVE Manager
support, and how do I get the app? on page 51. For more details about the app, see About VIVE
Manager on page 51.
Here's how to set up VIVE Focus Vision with VIVE Manager:
1. Turn on your headset.
2. Launch VIVE Manager on your phone. Read the permissions needed by VIVE Manager and
tap OK.
23 Getting started
To Next Page
Loading...
