Huawei B2368 - Page 124

Label Description
SIP TOS Priority Setting Enter the DSCP (DiffServ Code Point) number for SIP
message transmissions. The L
TE Device creates Class of
Service (CoS) priority tags with this number to SIP traf
fic that
it transmits.
RTP TOS Priority
Setting
Enter the DSCP (DiffServ Code Point) number for RTP voice
transmissions. The LTE Device creates Class of Service (CoS)
priority tags with this number to RTP traffic that it transmits.
Timer Setting
Expiration Duration Enter the number of seconds your SIP account is registered
with the SIP register server before it is deleted. The LTE
Device automatically tries to re-register your SIP account when
one-half of this time has passed. (The SIP register server might
have a different expiration.)
Register Re- send timer Enter the number of seconds the LTE Device waits before it
tries again to register the SIP account, if the first try failed or if
there is no response.
Session Expires Enter the number of seconds the LTE Device lets a SIP session
remain idle (without traffic) before it automatically disconnects
the session.
Min-SE Enter the minimum number of seconds the LTE Device lets a
SIP session remain idle (without traffic) before it automatically
disconnects the session. When two SIP devices start a SIP
session, they must agree on an expiration time for idle sessions.
This field is the shortest expiration time that the LTE Device
accepts.
Dialing Interval Selection
Dialing Interval
Selection
Enter the number of seconds the LTE Device should wait after
you stop dialing numbers before it makes the phone call. The
value depends on how quickly you dial phone numbers.
Phone Key Config
Use this section to customize the phone keypad combinations you use to access certain
features on the LTE Device.
If you dial the phone key which does not include the name with "one shot", you will hear a
"single sound" tone. If not, it means the phone key you dialed is wrong. After hearing the
"single sound" tone, hang up your phone and the corresponding feature will work.
For the feature with the name "one shot", you must dial the phone number you're going to
make after dial the phone key. You will not get any feedback from the device when you use
the "one shot" feature.
Caller Display Call This code is used to display the caller ID for outgoing calls.
Caller Hidden Call This code is used to hide the caller ID for outgoing calls.
LTE CPE B2368
User Guide
15 VoIP
Issue 03 (2019-01-31) Copyright © Huawei Technologies Co., Ltd. 116