Huawei B2368 - The Add New ACL Rule;Edit Screen

10.4.1 The Add New ACL Rule/Edit Screen
Click Add New ACL Rule or the Edit icon next to an existing ACL rule in the Access
Control
screen. The following screen displays.
Figure 10-7 Security > Firewall > Access Control > Add New ACL Rule/Edit
Each field is described in the following table.
Table 10-5
Security > Firewall > Access Control > Add New ACL Rule/Edit
Label Description
Filter Name Enter a descriptive name of up to 16 alphanumeric characters, not
including spaces, underscores, and dashes.
Y
ou must enter the filter name to add an ACL rule. This field is read-
only if you are editing the ACL rule.
Source Address
Type
Select
Single or Range depending on whether you want to enter a
single or a range of source IP addresses to which the ACL rule
applies. Select Any to indicate any source IP address.
Source IP
Address Start
Enter an IP address or the starting IP address of the source IP range.
Source IP
Address End
Enter the ending IP address of the source IP range.
LTE CPE B2368
User Guide
10 Firewall
Issue 03 (2019-01-31) Copyright © Huawei Technologies Co., Ltd. 84