Label Description
LAN Start Port This shows the port number to which you want the LTE Device to
translate the incoming port. For a range of ports, enter the first number
of the range to which you want the incoming ports translated.
LAN End Port This shows the last port of the translated port range.
LAN IP Address Enter the inside IP address of the virtual server here.
Protocol Select the protocol supported by this virtual server. Choices are TCP,
UDP, or TCP/UDP.
Apply Click Apply to save your changes.
Back Click Back to return to the previous screen without saving.
8.3 The DMZ Screen
Use this page to set the IP address of your network DMZ (if you have one) for the LTE
Device. All incoming packets received by this L
TE Device's WAN interface will be forwarded
to the default server you set.
Click Network Setting > NAT > DMZ to display the following screen.
NOTE
The configuration you set in this screen takes priority than the Network Setting > NAT > Port
Forwarding screen.
Figur
e 8-4 Network Setting > NAT > DMZ
The following table describes the fields in this screen.
Table 8-3 Network Setting > NAT > DMZ
Label Description
Default Server
Address
Enter the IP address of your network DMZ host, if you have one. 0.0.0.0
means this feature is disabled.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
LTE CPE B2368
User Guide
8 Network Address Translation (NAT)
Issue 03 (2019-01-31) Copyright © Huawei Technologies Co., Ltd. 73
To Next Page
Loading...
