LED COLOR STATU
S
Description
Blinking A telephone connected to the phone port has its
receiver of
f of the hook and there is a voice message in
the corresponding SIP account.
Of
f The phone port does not have a SIP account registered.
WPS /W
i-Fi
Green On Either IEEE 802.11bgn or 802.11ac is activated.
Blinking The LTE Device is communicating with wireless
clients.
Yellow Blinking The LTE Device is setting up a WPS connection.
Off The wireless network is not activated.
LTE
Signal
Strength
Green On Strong LTE signal: SINR ≥ 10 dB
Blue On Medium LTE signal: 10 dB > SINR ≥ 4 dB
Orange On Weak LTE signal: SINR < 4 dB
Blinking No LTE signal, searching, or disconnected.
LAN
0-2
Yellow
(Giga
Ethernet)
On The LTE Device has a successful 1000 Mbps Ethernet
connection with a device on the Local Area Network
(LAN).
Blinking The LTE Device is sending or receiving data to/from
the LAN at 1000 Mbps.
Green
(Fast
Ethernet)
On The LTE Device has a successful 10/100 Mbps
Ethernet connection with a device on the Local Area
Network (LAN).
Blinking The LTE Device is sending or receiving data to/from
the LAN at 10/100 Mbps.
Off The LTE Device does not have an Ethernet connection
with the LAN.
Refer to the Quick Start Guide for information on hardware connections.
1.5.3 The RESET Button
To reboot the device, just press down the RESET BUTT
ON and hold for 3-10 seconds, and
then release the button.
To restore the device to the factory default configuration, make sure the POWER LED is on
(not blinking) and press the RESET BUTTON for over 10 seconds.
If you forget your password or cannot access the web configurator, you can use the RESET
BUTTON at the back of the device to reload the factory-default configuration file. This
LTE CPE B2368
User Guide
1 Introduction
Issue 03 (2019-01-31) Copyright © Huawei Technologies Co., Ltd. 7
To Next Page
Loading...
