Label Description
Security Mode Select WP
A-PSK or WPA2-PSK from the drop-down list box.
Show Password
Select this to display the password as readable text.
Pre-Shared Key Type a pre-shared key from 8 to 63 case-sensitive ASCII characters.
more.../hide
more
Click more... to show more fields in this section. Click hide more to
hide them.
WPA-PSK
Compatible
This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security
mode to connect to your LTE Device. The LTE Device supports WPA-
PSK and WPA2-PSK simultaneously.
Encryption If the security mode is WPA-PSK, the encryption mode is set to TKIP
to enable Temporal Key Integrity Protocol (TKIP) security on your
wireless network.
If the security mode is WPA2-PSK and WPA-PSK Compatible is
disabled, the encryption mode is set to AES to enable Advanced
Encryption System (AES) security on your wireless network. AES
provides superior security to TKIP.
If the security mode is WPA2-PSK and WPA-PSK Compatible is
enabled, the encryption mode is set to TKIPAES MIX to allow both
TKIP and AES types of security in your wireless network.
5.3 The More AP Screen
The LTE Device can broadcast up to four wireless network names at the same time. This
means that users can connect to the L
TE Device using different SSIDs. You can secure the
connection on each SSID profile so that wireless clients connecting to the LTE Device using
different SSIDs cannot communicate with each other.
This screen allows you to enable and configure multiple Basic Service Sets (BSSs) on the
LTE Device.
Click Network Setting > Wireless (or Wireless 5G) > More AP. The following screen
displays.
Figure 5-6 Network Settings > Wireless > More AP
The following table describes the Labels in this screen.
LTE CPE B2368
User Guide
5 Wireless
Issue 03 (2019-01-31) Copyright © Huawei Technologies Co., Ltd. 44
To Next Page
Loading...
