Figure 10-5 Security > Firewall > Access Control
Figure 10-6 Security > Firewall > Access Control (After adding an ACL rule)
Each field is described in the following table.
Table 10-4
Security > Firewall > Access Control
Label Description
Rules Storage
Space usage(%)
This bar shows the percentage of the LTE Device's space has been
used. If the usage is almost full, you may need to remove an existing
filter rule before you create a new one.
Add new ACL
rule
Click this to go to add a filter rule for incoming or outgoing IP traffic.
Name This displays the name of the rule.
Src IP This displays the source IP addresses to which this rule applies. Please
note that a blank source address is equivalent to Any.
Dst IP This displays the destination IP addresses to which this rule applies.
Please note that a blank destination address is equivalent to Any.
Services This displays the protocol type and a port range that define the service
to which this rule applies.
Policy This field displays whether the rule silently discards packets (DROP),
discards packets and sends a TCP reset packet or an ICMP
destination- unreachable message to the sender (REJECT) or allows
the passage of packets (ACCEPT).
Modify Click the Edit icon to edit the rule.
Click the Delete icon to delete an existing rule. Note that subsequent
rules move up by one when you take this action.
LTE CPE B2368
User Guide
10 Firewall
Issue 03 (2019-01-31) Copyright © Huawei Technologies Co., Ltd. 83
To Next Page
Loading...
