Figure 4-2 Network Setting > Broadband > Broadband > Edit
The following table describes the fields in this screen.
Table 4-2
Network Setting > Broadband > Broadband > Edit
Label Description
Name This shows the name of the broadband connection.
Auto APN Select this to have the LTE Device configure the APN (Access Point
Name) of the L
TE network automatically
. Otherwise, enter the APN
manually in the field below.
APN Enter the Access Point Name (APN) of an LTE network, which your
service provider gave you.
MTU The Maximum Transmission Unit (MTU) defines the size of the largest
packet allowed on an interface or connection. Enter the MTU for this
WAN interface in this field.
NAT Enable Select this to activate NAT on the WAN.
IP Pass Through Select this to allow the ISP to assign IP addresses directly to the LAN
devices. This disables NAT and DHCP server configuration (Network
Setting > Home Networking > LAN Setup). The LTE Device will be
remotely managed by HTTPS and SNMP. Choosing this option also
displays more IP pass through configuration parameters.
LTE CPE B2368
User Guide
4 Broadband
Issue 03 (2019-01-31) Copyright © Huawei Technologies Co., Ltd. 30
To Next Page
Loading...
