Figure 8-2 Network Setting >NAT >Port Forwarding
The following table describes the fields in this screen.
Table 8-1
Network Setting > NAT > Port Forwarding
Label Description
Add new rule Click this to add a new port forwarding rule.
# This is the index number of the entry.
Status This field indicates whether the rule is active or not.
A yellow bulb signifies that this rule is active. A gray bulb signifies
that this rule is not active.
Service Name This is the service's name. This shows User Defined if you manually
added a service. You can change this by clicking the edit icon.
W
AN Interface This shows the WAN interface through which the service is
forwarded.
WAN Start Port This is the first external port number that identifies a service.
WAN End Port This is the last external port number that identifies a service.
LAN Start Port This is the first internal port number that identifies a service.
LAN End Port This is the last internal port number that identifies a service.
LAN IP Address This is the server's IP address.
Protocol This shows the IP protocol supported by this virtual server, whether it
is TCP, UDP, or TCP/UDP.
Modify Click the Edit icon to edit the port forwarding rule.
Click the Delete icon to delete an existing port forwarding rule. Note
that subsequent address mapping rules move up by one when you take
this action.
LTE CPE B2368
User Guide
8 Network Address Translation (NAT)
Issue 03 (2019-01-31) Copyright © Huawei Technologies Co., Ltd. 71
To Next Page
Loading...
