Installation Manual – Antenna & Feeder System Installation
BTS3802C & RRU Index
i-1
Index
A
antenna
appearance, 2-14
hoisting, 2-14
antenna and feeder system
testing, 2-45
antenna stand on cement base on roof
installation procedure, 3-6
introduction, 3-6
requirement of cement base, 3-5
structure, 3-6
antenna stand on iron tower
installation procedure, 3-4
requirement of iron tower, 3-3
structure, 3-4
antenna stand on parapet on roof
installation procedure, 3-7
introduction, 3-7
requirements for parapet, 3-7
antenna support on roof
installation flow, 2-10
installation requirement, 2-9
installing with wall, 2-12
installing without wall, 2-11
structure, 2-8
antenna support on tower
installation flow, 2-7
installation requirement, 2-5
structure, 2-4
assembling
directional antenna, 1-9
omnidirectional antenna, 1-7
D
directional antenna
accessory, 1-8
assembling, 1-9
interval requirement, A-1
directional antenna on roof
adjusting pitch angle, 2-32
appearance, 2-28
installation flow, 2-31
installation procedure, 2-31
installation requirement, 2-30
warn, 2-28
directional antenna on tower platform
appearance, 2-19
installation flow, 2-21
installation procedure, 2-21
installation requirement, 2-20
warn, 2-19
E
engineer label
feeder, B-1
introduction, B-1
jumper, B-3
F
feeder
cutting, 2-33
feeder grounding clip installation, 2-37
grounding, 3-12
grounding position, 2-39
hoisting, 2-33
laying, 2-36
laying and fixing sequence, 2-37
layout principle, 2-36
leading into equipment room, 2-43
routing, 3-12
testing, 3-14
feeder connector
adding, 1-4
typer, 1-4
To Next Page
Loading...
Need help?
General
