Installation Manual – Antenna & Feeder System Installation
BTS3802C & RRU
Appendix B
Engineering Label of Antenna & Feeder System
B-3
B.3.2 Label of Indoor Feeder
I. Contents
The contents of the indoor feeder label are the same as those of the outdoor label.
Please refer to "B.3.1 I. Contents".
II. Layout
The layout of an indoor feeder label is shown in Figure B-2.
ANT_00
40
150
10 30
ANT_00
Figure B-2 Indoor feeder label (unit: mm)
III. Usage
An indoor feeder label should be stuck to a feeder at the point 200mm away from the
connector.
When sticking the labels, make sure that their contents faces the proper direction so
that they can be easily viewed.
B.4 Engineering Labels for Jumper
B.4.1 Contents
The contents of the jumper label are the same as those of the outdoor label. Please
refer to "B.3.1 I. Contents".
B.4.2 Layout
The layout of a jumper label is shown in Figure B-3.
To Next Page
Loading...
Need help?
General
