Installation Manual – Antenna & Feeder System Installation
BTS3802C & RRU
Chapter 2
Installing RF Antenna & Feeder System
2-1
Chapter 2 Installing RF Antenna & Feeder System
2.1 About This Chapter
This chapter describes the installation of RF antenna and feeder system on tower
platform and on rooftop, including:
z Procedure of Installing RF Antenna & Feeder System
z Installing Outdoor Grounding Bar
z Installing Antenna Support on Tower
z Installing Antenna Support on Roof
z Hoisting Antennas
z Installing Omnidirectional Antenna on Tower Platform
z Installing Directional Antennas on Tower Platform
z Installing Omnidirectional Antenna on Roof
z Installing Directional Antennas on Roof
z Cutting Feeders
z Hoisting and Fixing Feeders
z Laying and Fixing Feeders
z Installing Feeder Window
z Leading Feeders into Equipment Room
z Installing Jumpers
z Testing Antenna & Feeder System
z Waterproof Treatment for Connectors and Feeder Window
2.2 Procedure of Installing RF Antenna & Feeder System
This chapter introduces the installation procedure of antenna & feeder system of
BTS3802C and RRU. The installation of antenna & feeder system can be
implemented either after or at the same time with the installation of the equipment.
The installation method and procedure may differ according to the different installation
environment and the antenna adopted. The project supervisor shall arrange the work
according to the engineering documents, the number of the installing personnel,
installation environment and the type of the antenna.
Figure 2-1 shows general installation procedure of RF antenna & feeder system. The
sections for reference are indicated in some steps in the figure below.
To Next Page
Loading...
Need help?
General
