Huawei HG8240 - Page 235

Context
The Wi-Fi wireless access service includes the Layer 3 bridge Wi-Fi service and the Layer 3
route Wi-Fi service.
l Layer 3 Wi-Fi service: Search for the SSID is performed on the PC. After the user passes
the verification, the PPPoE auto dialup is performed on the PC. The IP address is allocated
by the upper-layer BRAS. The ONT is connected to the OLT and then to the upper-layer
network in the Layer 3 mode to provide the high-speed Internet access service.
l Layer 3 route Wi-Fi service: Search for the SSID is performed on the PC. After the user
passes the verification, the PPPoE auto dialup is performed on the PC. The ONT is
connected to the OLT and then to the upper-layer network in the Layer 3 mode to provide
the high-speed Internet access service.
Procedure
l Layer 3 bridge Wi-Fi service
1. Configure the Wi-Fi parameters.
(1) In the navigation tree, choose Wi-Fi > Wi-Fi Basic Configuration.
(2) Select Enable Wireless to enable the Wi-Fi function. Then, set the parameters
as follows:
– SSID: ChinaNet-huawei
– Authentication Mode: WPA Pre-Shared Key
– Encryption Mode: TKIP&AES
– WPA PreSharedKey: chinahuawei
(3) Click Apply to apply the configuration.
2. Configure the parameters of the Layer 3 bridge WAN port.
(1) In the navigation tree, choose WAN > WAN Configuration.
(2) In the right pane, click New. In the dialog box that is displayed, configure
parameters of the WAN port as follows:
– WAN Connection: Enable
– Mode: Bridge
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual 3 Configuration
Issue 04 (2011-01-12) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-197