NOTE
l When X_HW_L3Enable is set to 0, it indicates that the corresponding LAN port works in the L2
mode.
l When X_HW_L3Enable is set to 1, it indicates that the corresponding LAN port works in the L3
mode.
By default, X_HW_L3Enable is set to 0.
Step 4 Configure the parameters of the WAN interface.
1. Choose InternetGatewayDevice > WANDevice > 1 > WANConnectionDevice from the
navigation tree. Click Add in the lower left part to create an instance.
2. Choose 2 > WANPPPConnection from the navigation tree and click Add in the lower left
part. Choose the new 1 branch from the navigation tree. In the right pane, set parameters
as follows:
l Set Enable to 1, indicating that the WAN connection is enabled.
l Set Connection Type to IP_Routed, indicating that the connection type of the WAN
interface is in routing mode.
l Set NATEnable to 1, indicating that the NAT function is enabled.
l Set Username to iadtest@pppoe and Password to iadtest, indicating that the PPPoE
user name is iadtest@pppoe and the password is iadtest.
l Set X_HW_SERVICELIST to INTERNET, indicating that the WAN interface
provides Internet access.
l Set X_HW_VLAN to 10, indicating the VLAN ID of the WAN interface is 10.
l Set X_HW_PRI to 1, indicating the priority level of the WAN interface is 1.
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual 3 Configuration
Issue 04 (2011-01-12) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-209
To Next Page
Loading...
