Huawei LampSite - 4.3.1 Installing an RHUB in a 19-Inch Cabinet or Rack

Installing an RHUB in a 19-Inch Cabinet or Rack
Installing an RHUB in a 19-inch cabinet or rack: Secure the mounting ear to the mounting bracket
by using M6 screws.
l If there is no other modules installed in the 1 U space near the RHUB, install the RHUB
directly. Otherwise, remove the modules before installing the RHUB.
l Before installation, you need to check the installation mode supported by the rack and adjust
the position of the mounting ear.
Figure 4-3 and Figure 4-4 show RHUBs installed in a cabinet or rack, respectively.
Figure 4-3 Installing an RHUB in a 19-inch cabinet or rack in standard mode
Figure 4-4 Installing an RHUB in a 19-inch cabinet in reverse mode
Installing an RHUB in a 19-Inch Shelf
When an RHUB is installed in a 19-inch shelf, the shelf must be installed on a wall. One shelf
can house multiple RHUBs with 1 U space between two RHUBs.
LampSite
Installation Guide
4 Installing an RHUB
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11