Figure 4-14 Removing mounting ears and screws
2. Use a torque screwdriver or Phillips screwdriver to tighten the four M4×8 screws with
a torque of 1.4 N•m to install the removed mounting ears again, as shown in Figure
4-15. The mounting ears must be aligned with the RHUB panel.
Figure 4-15 Installing mounting ears in standard mode
3. With one hand holding it, align the mounting holes with the installation holes, slowly
push the RHUB into the required position in the cabinet, as shown in Figure 4-16.
LampSite
Installation Guide 4 Installing an RHUB
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
20
To Next Page
Loading...
