1. With one hand holding it, align the mounting holes with the installation holes, slowly
push the RHUB into the required position in the shelf.
2. Use a torque screwdriver or Phillips screwdriver to tighten the four M6×16 screws
with a torque of 2 N•m, as shown in Figure 4-18.
Figure 4-18 Tightening screws
l The following describes how to install an RHUB with mounting ears installed in standard
mode:
NOTE
If necessary, request one more person for assistance.
1. Remove the mounting ears on both sides of the RHUB by removing the four M4×8
screws, as shown in Figure 4-19.
LampSite
Installation Guide
4 Installing an RHUB
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
22
To Next Page
Loading...
