Figure 5-25 Anchor points of the support for the AC/DC power adapter (unit: mm)
2. Use a hammer drill Ф6 to drill holes at anchor points, as shown in Figure 5-26 The
diameter of the hole is 6 mm, the depth is 25mm to 30 mm, and the interval of the two
holes is 50 mm.
Figure 5-26 Drilling holes and installing expansion bolts
3. Use two tapping screws to secure the power adapter support to the wall, as shown in
Figure 5-27.
LampSite
Installation Guide 5 Installing a pRRU
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
72
To Next Page
Loading...
