Procedure
Step 1 Use a marker to mark the two anchor points according to inter-hole spacing, as shown in Figure
5-31.
Figure 5-31 Marking anchor points
Step 2 Drill holes at the anchor points, and install expansion bolt assemblies, as shown in Figure
5-32. The diameter of the hole is 6 mm, and the depth is 25 mm to 30 mm.
Figure 5-32 Drilling holes and installing expansion bolts
Step 3 Place the Extender in the corresponding position and use an M4 Phillips screwdriver to tighten
the screws to 1.4 N•m, as shown in Figure 5-33.
LampSite
Installation Guide
5 Installing a pRRU
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
76
To Next Page
Loading...
