Mounting Structure Requirements
● The mounting structure where the SUN2000 is installed must be re resistant.
Do not install the SUN2000 on ammable building materials.
● Ensure that the installation surface is solid enough to bear the weight load.
● In residential areas, do not install the SUN2000 on drywalls or walls made of
similar materials with a weak sound insulation performance because the
noise generated by the SUN2000 is noticeable.
Figure 4-2 Mounting structure
Installation Angle Requirements
The SUN2000 can be support-mounted or wall-mounted. The installation angle
requirements are as follows:
● Install the SUN2000 vertically or at a maximum back tilt of 15 degrees to
facilitate heat dissipation.
● Do not install the SUN2000 at forward tilted, excessive back tilted, side tilted,
horizontal, or upside down positions.
SUN2000-(90KTL, 95KTL, 100KTL, 105KTL) Series
User Manual
4 Installation
Issue 11 (2020-08-30) Copyright © Huawei Technologies Co., Ltd. 29
To Next Page
Loading...
Need help?
General