OPERATION
16
Problem The fabric folds are wrinkled, creased, or gather unevenly.
Solution
Similar to clothing, Vignette
®
shades may require dressing throughout the life of
the shade. Dress the fabric by opening and closing your shade(s) several times
to realign the fabric folds.
The folds may also be dressed by hand with a gentle tug on each edge of the
fabric fold(s) where indentations appear.
Steaming Vignette Shades
For deeper wrinkles and creases, light steaming may be required. In lieu of
steaming, commercially available wrinkle release sprays may be used. Only the
face side of the shades should be sprayed, not the back liner. Depending on
style and fabric, slight wrinkles, puckers or other fabric variations may remain
and are inherent to this product. Do not steam the fabric on the headrail, bottom
rail, or back liners.
A “Fabric Steaming” video is available on YouTube (Vignette Modern Roman
Shades—Fabric Steaming—Hunter Douglas) and from Hunter Douglas Learning
and Development at my.hunterdouglas.com.
Problem The front fabric appears tocling to the backfabric.
Solution With the shade in the lowered position, lightly apply a static spray for home
furnishings. Follow the manufacturer’s directions on the can’s label.
Follow these steps:
1. Hold the can 6" to 8" from the fabric panel and lightly spray across the
fabric folds.
2. Raise and lower the shade 1 or 2 times to check for static reduction.
3. Allow the shade to dry in the fully lowered position.
If necessary, reapply the static spray each time the shade is professionally
cleaned.
Problem EasyRise
™
shades only: The universal cord tensioner has climbed to the
headrail.
Solution Pull down on the spring to relieve tension and pull the
universal cord tensioner to the bottom of the cord loop.
Properly mount the cord tensioner. See “Attach the
Universal Cord Tensioner — EasyRise
™
Shades Only”
on page10 and/or the instructions included with
your Universal Cord Tensioner Installation Kit.
Universal
Cord
Tensioner
To Next Page
Loading...
