Hunter ICC2 - Programming: Run Times and Water Days; Setting Station Run Times; Setting Water Days; Selecting Odd or Even Days to Water

24 hunter.direct/ICC2help
Programming the Controller
SETTING STATION RUN TIMES
1. Turn the dial to the Run Times position.
2. Press the PRG button to select A, B, C, or D.
3. The run time for station 1 will be ashing. Use the + and –
buttons to change the station run time. You can set
station run times from 1 minute up to 12 hours.
4. Press the ► button to advance to the next station.
5. Repeat for each station and program that you wish to run.
6. Total Run Time Calculator: Turn the dial to the Run Times
position. Press the ◄ button to view total run time for all
stations in the program. Press PRG to see total run times
for other programs.
SETTING WATER DAYS
1. Turn the dial to the Water Days position.
2. The display will show the last program selected (A, B, C, or
D). Switch to desired program by pressing the PRG button.
3. The pointer at the bottom of the screen will be blinking
above “MO” (Monday). Press the + or – buttons to select
days for watering () or no water ( – ).
4. Aer selecting to whether to water for a specic day, the
pointer will automatically advance to the next day. You can
also toggle between individual days by pressing the
► and ◄ buttons.
SELECTING ODD OR EVEN DAYS TO WATER
This feature uses numbered days of the month for watering,
instead of specic days of the week (i.e., odd: 1st, 3rd, 5th,
etc.; even: 2nd, 4th, 6th, etc.).
1. Press the ► button past all days of the week so the pointer
is blinking above “ODD” or “EVEN.”
2. Press the + button to select or the – button to cancel Odd
or Even days.