Built on Innovation
®
25
Programming the Controller
SELECTING INTERVAL WATERING
This feature is convenient if you want to have a more
consistent watering schedule without having to worry about
specic dates or days of the week. The interval number
represents the actual interval of days during which watering
will occur.
1. Press the ► button past “ODD” and “EVEN” until pointer is
blinking above “INTERVAL.”
2. The number of interval days will be shown blinking (the
default setting will be 1).
3. Press the + or – buttons to increase or decrease the
interval days (up to 31 days).
4. Once the interval days are greater than 1, a second number
will appear indicating days remaining in the interval.
Press the ► button to select this number and press the +
or – buttons to increase or decrease the days remaining
until next watering. This number represents the desired
number of days until the next watering. For example, if you
select an interval of 3 days with 1 day remaining, watering
will begin tomorrow at the scheduled start time(s), and will
repeat the schedule every third day from that day forward.
5. Within the Interval Watering mode, there is also a No
Water Days option. Aer setting your interval days and
days remaining, press the ► button to select individual
non-water days. The default setting shows all days
available for watering. Press the ► and ◄ buttons to toggle
between days, and the – button to set any specic day(s)
you do not want to water. A will indicate which days are
set as non-water days.
To Next Page
Loading...
Need help?
General
