Hunter TCX50 - Page 32

Operation Instructions for TCX50 Tire Charger
37
Do not stand over tire during ination.
WARNING
Step down completely on the air ination pedal (pedal on the left side of the base) to release a
high-pressure air blast through jets on the clamps to assist in seating the beads of the tire.
AIR-JET
FROM HERE
To increase the effectiveness of the ination jets, always liberally lubricate beads
and raise the lower bead while activating ination jets.
NOTICE
Step down partially on the pedal to inate tire and seal beads with ination hose. Frequently
stop to check bead seating pressure on gauge.
Do not exceed tire manufacturer’s maximum pressure as stated on the sidewall of
the tire when seating beads.
WARNING
Reinstall valve stem core into the valve stem after beads have been seated, and then inate
tire to vehicle manufacturer recommended pressure.
Activate air ination jets only when sealing bead.
Bleed air pressure from system before disconnecting supply line or other pneumatic
components. Air is stored in a reservoir for operation of ination jets.
Only activate the air ination jets if the rim securing device is locked in place and
the tire is properly clamped.
WARNING