5. Attach the plate to the arm with the 4 screws
(4 mm hex key).
Note: The plates are in 2 dimensions to fit
different dimensions of the post. Select the
applicable plate for your installation.
6. Put the reference station on top of the post.
Note:
The reference station must be
installed at the top of the post.
7. Attach the reference station to the post with
the 2 screws (5mm hex key).
8. Connect the low-voltage cable to the
reference station and the power supply.
Refer to
To examine where to put the power
supply on page 19
.
9. Attach the low-voltage cable to the wall from
the reference station to the power supply
with cable ties.
1460 - 002 - 06.04.2020
Installation - 25
To Next Page
Loading...
