EasyManua.ls Logo

Husqvarna ProFlex 21 - Page 43

Husqvarna ProFlex 21
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English-41
MAINTENANCE
3. Remove the foam rubber pre-lter and clean using
a mild detergent.
Squeeze it dry with a clean cloth.
4. Remove the wing nuts for the air lter and remove
the paper lter.
5. Tap the paper lter against a xed surface to
remove dust.
If the paper lter is still dirty, it must be replaced.
6. Ret the air lter as follows:
Check that the seal on the bottom of the paper
lter is whole. Fit the paper lter in the air lter
housing and tighten the wing nuts.
7. Ret the pre-lter on the paper lter.
8. Replace the cover over the air lter housing.
Do not over tighten the plastic fasteners.
8009-180
8009-182
8009-181
IMPORTANT INFORMATION
Do not use compressed air to clean the paper
lter.
Do not wash the paper lter.
Do not oil the paper lter.

Table of Contents

Related product manuals