Safety circuit
activated
Driver’s seat switch
Parking brake sensor
Sensor hydrostatic pedals
Switch power take-off
(Press in - Pull out)
Check the LED in the sensor
Check the LED on the circuit
board
Solenoid clutch
clock function
Fuse FU 1 tripped
Change the fuse.
Localise the fault
Measure coil resistance
page 127
Rear drive belts broken or
slips
The belts broken / worn / oily
Belt tensioner defective
Solenoid clutch defective
Replace / clean the belts
Check springs, roller.
and bearing
Repair / lubricate
Propeller shaft missing
Assembling
Angle gear mechanical faults Replace / repair
The cutting unit's drive belt
broken or slips
The belt broken / worn / oily
Belt tensioner defective
Replace / clean the belt
Check spring, roller.
and bearing
Repair / lubricate
Pulley slips on axle Key missing
Replace damaged parts
High gear mode
Check that the rear wheels do
not drive.
Electrical fault?
Hydraulic fault?
Trouble shoot according to
page 124
Trouble shoot according to
page 131
Replace the solenoid clutch
Cutting unit does not work
To Next Page
Loading...
