34
1. START MODE :
Select the initial measurement mode.
- Normal : Select the initial measurement mode to normal lens measurement mode.
- Prog : Select the initial measurement mode to progressive lens measurement
mode.
- Auto : Select the initial measurement mode to auto detect mode.
- Contact : Select the initial measurement mode to contact lens measurement mode.
2. SINGLE LENS
Enable a single lens measurement mode.
- Off : Disable the function.
- On : Enable the function.
3. AUTO R/L
Choose to enable auto-determination of left/right lens function.
- Off : Disable the function.
- On : Enable the function.
(Initial mode is right lens measurement mode. However, if the single lens is on, initially
state is a single lens mode state.)
4. AUTO MSR NORMAL
Choose to enable a function to automatically save lens data when the center
of the lens is aligned on normal lens measurement mode.
- Off : Disable the function.
- On : Enable the function.
5. AUTO MSR PROG
Choose to enable a function to automatically save lens data when the center of the
lens is aligned on progressive lens measurement mode.
To Next Page
Loading...
